Kitchen Faucet Installation Made Easy: Expert Advice

The faucet is one of the essential hardware accessories for kitchens and bathrooms. Although the structure of a faucet may seem extremely simple, achieving a seamless installation requires considerable effort. So, how do you install a kitchen faucet? Let's learn together.

How to Install a Kitchen Faucet

1. First, turn off the water supply valve, then connect the two water supply hoses to the faucet. The connections differ in length; install the shorter one first, followed by the longer one. Next, feed the two water supply hoses through the hole reserved in the sink and secure the faucet from underneath with a nut. The other end of the water supply hoses should be connected to the water supply pipes. If you are installing a hot and cold water faucet, make sure to distinguish between the hot and cold water pipes. Then wrap waterproof tape around the connections and tighten them with a wrench. Finally, turn on the water supply valve and check for any leaks in the faucet.

2. The kitchen faucet is used frequently, so it must be installed firmly. Additionally, because kitchen faucets are often moved, they can easily become loose. Therefore, make sure to tighten the locking nut securely. Kitchen faucets mainly include two types: thermostatic faucets and single handle faucets.

3. If you are installing a thermostatic kitchen faucet, check whether the water pipes are configured with hot water on the left and cold water on the right before installation. Connecting the hot and cold water pipes incorrectly will result in the faucet not functioning properly. Moreover, gas and solar water heaters cannot use a thermostatic faucet due to insufficient water pressure. When installing the thermostatic faucet, remember to install the hot and cold water filters as well.

4. If you are installing a single handle kitchen faucet, pay attention to the following two points:

(1) Typically, single handle mixing basin faucets come with installation dimension charts and user manuals upon leaving the factory. Before installing the single handle faucet, open the packaging to check if all components are complete. The faucet components usually include: a full set of fixing bolts and copper plates, a complete basin pull-up drain assembly, and two water supply hoses.

(2) You should also move the faucet handle up and down, left and right. It is best if the handle operates smoothly with a slight, uniform resistance feeling. Additionally, check the electroplated surface for brightness; it should be free from bubbles, spots, and scratches.

5. Installation Tools

When installing a kitchen faucet, the main tools you will need include hoses, a wrench, a showerhead, a drain, elbows, decorative caps, rubber washers, etc. Before installing the kitchen faucet, ensure that all matching components are complete.

Before installing the kitchen faucet, it is crucial to check that all the accompanying parts are available. The above information is a guide on how to install a kitchen faucet. Friends who need to install a kitchen faucet can take a detailed look at this information, and I hope it helps everyone.