Which Side is the Toilet Water Inlet Located On？

We are no strangers to toilets, but some people may not know where the water intake is located. Let's take a look together with the editor.

Where is the water intake of the toilet located？

Generally speaking, the water intake of the toilet is on the left side. The height of the angle valve installation must follow the standard of 0.25 meters. The gap between the toilet's drainage outlet and the wall should be determined based on the layout of the bathroom and personal preference.

How to install a toilet？

1、Before installation, check the conditions. Ensure that the bathroom is level and that the drainage flows smoothly. Also, verify that the bathroom dimensions match the reserved dimensions. If the floor is uneven, it must be leveled before installation to avoid affecting the installation results later.

2、After checking everything, you can mark the sewage pipe and drain position of the toilet to facilitate the installation of the toilet.

3、Then, use an electric drill to drill a hole and embed an expansion screw. Next, install a sealing ring on the bathroom drain. Make sure the pipe from the bathroom and the drainpipe are aligned properly. Apply a layer of silicone sealant or cement slurry on the sewage pipe to prevent leaks during drainage.

4、Install the bathroom accessories. Tighten all screws, adjust the tank fittings, and connect the water pipe. Before installation, check that the water valve switch is functioning properly and that the pipe connecting to the bathroom is of appropriate length and space.

5、Finally, adjust the toilet, which is an important step after installation. If the drainage pipe is unobstructed and water can flow normally, the toilet installation is considered complete.

Article Summary：That's all for where the toilet water intake is located and how to install a toilet. If you want to learn more, please continue to follow Hawkrown, as we will have more exciting content for you in the future.