How to Fix and Replace Your Broken Floor Drain

The floor drain serves a drainage function, so if it fails to drain during use, it needs to be replaced. Below, I will introduce how to replace a broken floor drain.

How to Replace a Broken Floor Drain

1. First, use tools to remove the floor drain from the joint. If it's too hard, you may need to use a hammer.

2. Next, take out the floor drain and stuff a plastic bag into the opening to prevent debris from entering. Then, clean up the surrounding cement.

3. Finally, apply new cement putty around the drain pit, install the floor drain, and clean up any excess cement putty. Then, cover it with a panel.

Types of Floor Drains

1. Shallow Water Seal Floor Drain

This type of drain does not have an odor prevention feature on its own; it relies on water to achieve deodorizing effects. Essentially, it isolates the upper and lower layers of the drain. It needs to be cleaned regularly after use, or it may become dirty over time and fail to function correctly.

2. Flap Floor Drain

This drain has a built-in spring that requires manual control to open and close. It is relatively difficult to clean and is gradually being phased out since the spring can easily wear out over time.

3. Deep Water Seal Floor Drain

Deep water seals are similar to shallow ones, but the water seal layer is raised to 7-8 cm to enhance odor prevention. This type of drain has a medium drainage speed and can prevent backflow, but it is also quite challenging to clean. It's essential to check that the height of the drain pipe matches before purchasing.

4. T-type Floor Drain

This type not only has good insect prevention features but also excellent filtration. It has a fast drainage speed, but it can be cumbersome to clean. Over time, the spring may also wear out, necessitating the replacement of the internal components.

In summary：this concludes the information on how to replace a broken floor drain. By following the steps outlined above, you can successfully replace it. It is crucial to pay attention to the order of operations during the replacement to avoid complications during later use.