DIY Sensor Faucet Installation: Everything You Need to Know

In some malls or office buildings, sensor faucets are quite common. Many homeowners also choose to install sensor faucets at home, as they are more fashionable and aesthetically pleasing. Here’s how to install a sensor faucet and why it might not be dispensing water.

1.How to Install a Sensor Faucet

First, you need to close the water valve at the location where you will install the sensor faucet, then secure the faucet onto the sink.

Next, there’s a battery compartment on the top; open it and insert the battery, paying attention to the positive and negative ends. You will see the red light flashing continuously. Wait until the flashing stops, then close and secure the battery compartment.

After that, turn on the water valve and adjust it to the water-dispensing position, then check if water flows normally. If everything is fine, you can start using it.

2.Precautions When Installing a Sensor Faucet

When installing the sensor faucet, ensure that the sensor window is facing down, and the distance between the faucet and the sink should not be less than 25 cm, otherwise, it will affect the sensitivity of the faucet and may result in poor response.

Before installation, make sure to close the inlet valve to prevent leaks due to improper installation.

You should wrap the faucet with threads or use a plastic bag before securing it in place.

The sensor faucet requires batteries; typically, four AA batteries are used. After installing the batteries, you should see the indicator light flashing.

3.Why the Sensor Faucet Might Not Dispense Water

Sometimes when you place your hands under the faucet, there is a long delay before water comes out. This could be due to a malfunction in the sensing mechanism, which may need to be replaced. It might also be because the batteries are dead, so replacing the batteries might resolve the issue.

Another possibility is that there is something obstructing the bottom of the faucet. In this case, if your hands are placed underneath, the sensor may not detect them, so it’s necessary to clean the area under the sensor faucet. Doing so might help resolve the problem.

In summary, sensor faucets are quite common in our lives and can also be installed in homes. However, it’s important to follow certain procedures to install the sensor faucet properly so that it operates as intended.