Easy Steps for Replacing LED Bathroom Heater Lights

In winter, bathtubs provide us with warmth. However, it is well known that the power consumption of bathtubs is very high, and the LED lights inside often burn out easily. So, how do you replace the LED lights in a bathtub when they go out? Today, I will teach you how to change them.

How to replace the LED lights in a bathtub

The LED lights in the bathtub are combined with the heating components. To replace the LED lights, you need to remove the entire panel. You can press the edge buttons to detach it. Be careful not to pull too hard to avoid breaking the wires. Finally, open the cover and replace it with the same brand of LED lights, then reinstall it in the original way.

Which type of bathtub heater is better?

1. Wind Warm Bathtub Heater

Advantages: The wind warm bathtub heater has a high safety performance. It does not rely on high-temperature sources for heating, allowing it to operate safely in moist environments without safety hazards. It offers a wide and even heat distribution. Disadvantages: The wind warm bathtub heater is relatively expensive. Its biggest drawback is that it is slow; even for a bathroom that is just 3-5 square meters, it takes about 10 minutes to warm up before you can take a bath.

2. Light Warm Bathtub Heater

Advantages: This type represents a high cost-performance ratio; it is inexpensive but has excellent thermal efficiency, warming the entire bathroom in just one to two minutes. It is highly practical, visually appealing, and can also serve as a decoration for the bathroom. Disadvantages: There are safety risks associated with it. Operating in a moist environment poses certain risks.

3. Carbon Fiber Bathtub Heater

Advantages: The carbon fiber bathtub heater uses carbon fiber inside the carbon fiber tube to generate heat through far-infrared radiation and then blow the heat out. It has a high heating efficiency and warms up quickly, also providing certain health benefits. Disadvantages: The quality of its overheating protection device (or insulation device) is a factor that needs to be considered.

In conclusion：this is all about how to replace the LED lights in a bathtub. For safety reasons, when purchasing a bathtub heater, it is essential to pay attention to its quality and not to go for cheaper options.