How to Easily Replace a Faucet in Your Bathroom Sink

If there is a problem with the faucet in the washbasin, you will need to choose a new faucet for replacement. However, many people don't know the correct way to replace it. Today, I will guide you through the process.

1. How to replace the washbasin faucet

Before replacing the faucet, shut off the main water valve in your home and turn on the faucet to drain all the water inside. You can start by disconnecting the incoming water pipeline that is connected to the angle valve. Use a wrench to hold the water pipe with one hand while turning the wrench with the other hand to easily detach the hose.

Next, remove the fastening components. There is a nut that may be tightly locked; you can use pliers or a wrench to unscrew it, and finally take out the entire faucet.

Install the new faucet by taking out the fixed base, rotating the nut off the pipeline, inserting the hose properly, and connecting it to the angle valve. Tighten it. Then, install the handle of the faucet and secure it in place. If everything looks good, tighten the nut at the end to complete the installation.

2. Precautions for disassembling the faucet

In fact, installing the faucet is relatively simple; the main concern is during the disassembly process. Since some hoses may have been embedded deep over time, it might take extra time to detach them. Use a screwdriver to turn the screws counterclockwise to push the hose out. While doing this, be careful not to damage the sealing ring inside; if it breaks, it will affect the sealing effect, and then you can remove the hose.

Some hoses might have problems with aging or rust due to prolonged use. If you find it difficult to unscrew, apply a few drops of lubricant to the rusty area and wait for a while. The hose will become much easier to remove with the wrench afterward.

In summary, the above content covers how to disassemble the faucet and how to install a new one. Before disassembling, it's crucial to turn off the main valve in your home and let the water drain out. After that, follow the correct method to operate.