The Ultimate Guide to Flushing Your TOTO Toilet

When it comes to Toto toilets, many consumers are familiar with them and they are quite popular. So, how do you flush a Toto toilet? Let's take a look at the relevant information.

How to Flush a Toto Toilet：

Toto toilets are divided into smart toilets and regular toilets. Smart toilets flush automatically via sensors. When a person stands up, the toilet will automatically activate the flushing mode. Alternatively, there is also a side flush button for manual flushing when standing up. It’s important to note that a person should wait at least 6 seconds before sitting down again, as the body sensor requires this time to reset.

For regular toilets, you simply need to press the flush button on the tank. The tank has one large and one small button, representing a large and small water discharge, respectively. In most cases, the small flush is sufficient to clean the toilet. If you’re concerned about the toilet clogging, you can press both buttons simultaneously for a stronger flush that helps clear blockages.

What to Do If the Smart Toilet Flushes Weakly：

一、Reasons for Weak Flushing in Smart Toilets

1、If the water tank is not filled correctly, for instance, if it contains a low water level, the flushing pressure may not be optimal, leading to weak flushing. Additionally, aging or damaged internal components of the tank can also cause weak flushing.

2、If the toilet has not been cleaned regularly, accumulated dirt inside the pipes can result in slow flushing.

3、If the water inlet valve was not installed at the correct water level, it may be too low, leading to poor flushing performance.

二、Expert Advice: Strengthening the Flush of Your Smart Toilet

1、Ensure the water tank is full, ideally reaching 2/3 capacity or completely full. Adequate water levels will resolve weak flushing issues.

2、If there are many obstructions inside the pipes, conduct a thorough cleaning to clear any blockages, which will enhance flushing effectiveness.

3、If the water level in the inlet valve is low, disassemble the inlet valve and adjust the position of the clip to increase the water level, then reassemble to solve the problem.

Conclusion：This concludes the information on how to flush a Toto toilet. I hope this is helpful for you. For more related knowledge, please continue to follow the Hawkrown online consultation platform.