How to Install a Five-Wire Bathroom Heater: A Step-by-Step Guide

The bath heater, an important appliance in the bathroom, requires safe wiring to ensure its proper use. Let's take a look at how to install the five wires of the bath heater.

How to Install the Five Wires of the Bath Heater

1. Prepare the wiring in the bathroom and reserve the appropriate position for the bath heater installation.

2. Use the neutral wire for power supply to complete the circuit.

3. The N terminal is the neutral wire terminal, which is usually pre-connected by the merchant.

4. Then, connect the live wire to the corresponding control panel, ensuring to choose matching colors to avoid mistakes during wiring.

How to Clean and Maintain the Bath Heater

1. Do not spray water while using it.

Although it has certain waterproof capabilities, it operates with electricity, and the internal components cannot get wet. Therefore, do not spray water directly; otherwise, water may enter and cause a short circuit, affecting normal use.

2. Avoid frequent switching of the bath heater.

When in use, do not frequently turn the product on and off, as this can damage internal components and bulbs. It is important to pay attention to this point.

3. Do not turn off the bath heater immediately after use.

Many people prefer to turn off the bath heater right after taking a shower, but this is incorrect. After showering, there is still a lot of moisture in the room that must be expelled. Wait until all the moisture is cleared before turning off the bath heater.

4. Exterior cleaning.

Regularly check for dirt accumulation, especially on the surface. You can remove the spring from the housing and use a cleaning agent to wipe the surface and bulbs.

5. Interior cleaning.

When cleaning the interior of the appliance, safety is paramount. First, turn off the power, then carefully remove the bulbs inside. Use a cloth dipped in cleaning solution to wipe, and afterward, dry the surfaces with a clean cloth.

6. Cleaning the switch.

The switch also requires cleaning, as its surface can accumulate dirt. Always turn off the power before cleaning and use a slightly drier cloth to wipe it to prevent electric shock hazards.

In summary：the above is about how to install the five wires of the bath heater. I believe everyone understands it now! Proper installation of the bath heater requires certain skills, so if you're not familiar with the installation process, it's best to hire a professional.