The Ultimate Guide to Swapping Out Hot and Cold Water Faucet Hoses

Both the bathroom and kitchen use hot and cold water faucets, which are connected to hoses. So, how do you replace the hoses for hot and cold water faucets? Let's take a look!

1. Disconnect the water supply pipe and hose

Before making the replacement, first, turn off the valve; otherwise, water will flow during the change, affecting the installation. The valve is usually located underneath the sink, and you can simply turn it off. Then, use a tool to separate the water supply pipe from the hose. Typically, the water supply pipes in the bathroom are exposed, making them easier to detach, but be careful not to apply too much force that could break the pipe. When disassembling, hold the water pipe with your left hand and use your right hand with a wrench to unscrew, allowing you to disconnect the water pipe and hose.

2. Separate the faucet from the sink

Next, remove the fixing accessories on top of the faucet and take it off the sink. At this point, you can see the hose. If it has been in use for a long time, the hose may show signs of aging, and the fixing parts may be rusted, making it difficult to unscrew with a wrench.

3. Use a saw to cut off the connection

As we know, the space under the sink is relatively small, making disassembly cumbersome. In this case, you can remove the sink to make it easier to take off the faucet. Next, use a saw to cut off the rusted part, and the faucet can be quickly removed.

4. Assemble and secure the faucet

Now start the installation steps by placing the pipe onto the faucet and connecting it properly. Then, connect the screw rod to the faucet's interface, and put the rubber ring on top of the faucet. Next, reconnect the faucet to the sink, add a rubber pad, and finally use a wrench to tighten the screws.

5. Replace the hose

Lastly, install the hose. The internal valve of the hot and cold faucet is three-way, allowing only one hose connection, but you still need to install the other hose. Therefore, the other end should be sealed with a threaded plug to ensure the faucet functions normally.

In summary, the above describes how to change the hoses for hot and cold water faucets. I believe everyone understands now! The hoses of hot and cold water faucets are very important, and if they get damaged, they should be replaced promptly, ensuring that the models remain consistent to prevent affecting normal water flow.