Instant Water Heater Faucet Installation Made Easy

There are many types of faucets on the market, among which instant hot water faucets are favored by numerous consumers. The installation process of an instant hot water faucet can be simplified into five steps. Below, I will introduce these steps.

1. Preparation

Before installing the instant hot water faucet, first open the faucet packaging, check the components, and inspect the faucet for any quality issues, such as any damage or deformation in the plastic shell. Prior to installation, it is advisable to review the installation manual and turn off the water valve of the existing faucet in your home.

2. Fixing the Faucet

First, screw the faucet's water outlet pipe into the main unit's installation hole. Then, insert the copper pipe and electrical wire at the bottom of the main unit into the sealing ring. Next, insert the faucet into the installation hole on the countertop. Following this, secure the faucet by placing the fixing plate and fixing nut onto the faucet's copper pipe from beneath the countertop, and tighten the fixing nut.

3. Connecting the Hose

When installing the connecting hose, wrap about ten turns of waterproof tape around the lower end of the faucet's copper pipe. Then, insert one end of the metal hose onto the copper pipe and tighten the nut to secure the hose. Repeat the same process to connect the other end of the metal hose to the water valve interface. When connecting the hose to the water valve, be sure to place the filter net rubber gasket at the connection point.

4. Installing the Plug

If the plug of the instant hot water faucet is not properly connected, we need to correctly install the leakage protection plug. Use pliers to strip a part of the electrical wire, and then remove the back cover of the leakage protection plug to access the connection terminals. Use a screwdriver to loosen the terminal screws and wrap the corresponding live, neutral, and ground wires around the terminal posts, then tighten the screws. Ensure that the wires are correctly connected and not reversed during the installation of the plug.

5. Testing

After the instant hot water faucet is installed, first open the water valve of the faucet, then loosen the handle of the instant hot water faucet to turn it on. Check for any leaks during the operation of the faucet. Once the faucet is functioning properly and water is flowing, turn it off, reinsert the leakage protection plug, and turn the faucet handle to the hot water position to verify that the faucet can deliver hot water normally.

In summary, I have briefly introduced how to install an instant hot water faucet. I hope this article helps provide reference and assistance for your future installation of such faucets. For more related information, you are welcome to continue following Hawkrown.com.