Steps to Stop Water Leakage at Your Kitchen Faucet Swivel Joint

The faucet in the kitchen sink is prone to leaking problems after prolonged use, such as leaks at the rotational joint of the faucet. A leaking faucet can be repaired by following these four steps, which are outlined below.

1. Turn off the Angle Valve

The angle valve for the faucet is usually located beneath the sink. Once you locate the angle valve, turn it clockwise to close it. Generally, there are two angle valves for kitchen faucets—one for hot water and one for cold water—so both valves need to be closed.

2. Disassemble the Faucet

First, open the faucet to drain any remaining water inside. Then, use a wrench to loosen the fixing nut connecting the angle valve and the hose. Disconnect the hose from the angle valve. Next, loosen the fixing nut located beneath the faucet and remove the sealing gasket, washer, and nut together. Finally, pull the faucet out of the sink and rotate to remove the two inlet hoses from the bottom of the faucet.

3. Repair the Faucet

After disassembling the faucet, check the O-ring seal of the hose and the gaskets for any damage. Typically, leaking at the rotational joint of the faucet is caused by a worn gasket; therefore, you can replace it with a new one. After replacing the damaged parts, reinstall the faucet. Connect the hose to the faucet, insert it into the sink hole, and then put on the sealing gasket, washer, and tighten the nut. Finally, connect the other end of the hose to the angle valve.

4. Check for Leaks

After repairing the faucet, you can turn on the angle valve and rotate the faucet switch to check if there are any leaks.

In summary, this is a simple guide on how to address a leaking faucet at the rotational joint in the kitchen sink. I hope this article provides some useful reference and assistance for future faucet repairs. If the faucet continues to have issues, you may also consider replacing it with a new one. For more related information, please continue to follow Hawkrown.com.