How to Reinstall a Dropped Bathroom Heater: A Step-by-Step Guide

If the bathroom heater is not installed correctly, it can easily fall down, so it needs to be reinstalled. Let's take a look at how to install a fallen bathroom heater.

How to reinstall a fallen bathroom heater

1. Install the ventilation window

Before installing the bathroom heater, you need to install the ventilation window first, as the heater requires the release of gases during use. Therefore, the installation of the ventilation window is crucial. First, determine the location of the ventilation hole on the wall and drill a hole in the wall. Install the ventilation window and then connect one end of the ventilation duct to the ventilation window. Make sure to seal the gaps around the ventilation duct with cement.

2. Determine the installation position

Next, you need to determine the position for the bathroom heater. The position of the heater is very important; it should typically be installed directly above the shower area to ensure optimal installation effectiveness. Additionally, pay attention to the height of the heater—the light bulbs should be placed 2.1 to 2.3 meters above the ground. It should not be too high or too low.

3. Secure the bathroom heater

Once the position is determined, you can secure the bathroom heater. First, remove the upper cover and unscrew the light bulbs. Take out the springs from the cover. Then, firmly attach the base of the heater to the ceiling, ensuring it is securely installed to prevent it from falling after prolonged use.

4. Wiring

After securing the heater, proceed to connect the wiring. This step is crucial; if the wiring is not done correctly, it will affect the heater's performance. Pull the power line out from within the ceiling and connect it to the heater's terminal block, then cover the terminal block and secure it with screws. Any excess wiring from the ceiling should be tucked back into the ceiling to prevent electric shock.

5. Connect the ventilation duct

After installation, you should also connect the ventilation duct. Simply attach one end to the exhaust outlet of the heater. Finally, reinstall the upper cover by aligning its positioning feet with the positioning slots on top.

In summary:The above is about how to install a fallen bathroom heater. I believe everyone understands it now! The installation steps for the bathroom heater are quite numerous and require specialized methods; otherwise, improper installation will affect its usage.