Home / Blog Center / Chargers / Faucet Installation Made Easy: Hot and Cold Water Hose Setup

Faucet Installation Made Easy: Hot and Cold Water Hose Setup

09/01/2025 | Hawkrown

The installation of hot and cold water hoses for faucets must be handled properly; otherwise, it will affect their use in the future. Let’s take a look at how to install the hot and cold water hoses for the faucet together with the editor.

1. How to install the hot and cold water hoses for the faucet

First, turn off the main water valve indoors, and then disconnect the problematic hose joint from the water inlet pipe to remove the faucet, paying attention to the strength to avoid damage.

Next, install the prepared new water hose and secure it with pliers. At this time, try not to use sealing tape as it may not be favorable for long-term use.

Following the order in which the hot and cold water pipes were removed, install the new hot and cold water pipes in reverse, and then reattach the previously removed panel, and it will be done.

2. What to pay attention to when installing hot and cold water pipes

When installing hot and cold water pipes in the bathroom, special attention should be paid to ensure that the pipes run along the top as much as possible and that they are level and vertical, without any bending. When arranging the hot and cold water pipes, they must be kept at a safe distance from the electrical circuits. Additionally, the installation of hot and cold water pipes should be carried out by professionals to reduce safety risks.

The distance between the cold and hot water pipes must be controlled properly; they should not be too close together, and the outlets of both water pipes should be level. Furthermore, the outlets for cold and hot water should be clearly marked to avoid scalding incidents. Normally, hot water is on the left, and cold water is on the right.

The installation positions of various valves also need special attention. They must be installed correctly with high flatness to facilitate future maintenance in case of problems. Additionally, the hot and cold water pipes are installed through the wall, which requires grooving, and the depth of the groove must be controlled. Hot and cold pipes should not be in the same groove.

In summary, this is how to install the hot and cold water hoses for faucets and what to pay attention to during the installation of water pipes. Have you understood it? It’s advisable to avoid any issues during the installation of the faucet's hot and cold water pipes to prevent unnecessary troubles in the future.

Contact Us

Submission Successful

ok