Understanding the Differences Between Bath Heater Type 1 and Type 2

Modern bathrooms generally use a heater known as a "bath heater" for warmth. The bath heater has two settings, labeled as heating 1 and heating 2. Let's take a look at the differences between these two settings.

Differences Between Bath Heater Heating 1 and Heating 2 The main difference lies in the temperature, with heating 2 providing a higher temperature than heating 1. During use, if the indoor temperature is relatively high, heating 1 will suffice. However, if the indoor temperature is low, you should switch the bath heater to heating 2. It's important to note that during use, water should not splash onto the heater, as it lacks waterproof capabilities, which could lead to a power short circuit when it comes into contact with water.

Precautions When Using a Bath Heater

1. Electrical wiring must be standardized

The power of a bath heater exceeds 1100W, so the accompanying electrical wiring should utilize waterproof cables, preferably multi-strand copper wire with a diameter of no less than 1 mm. All electrical wiring must be routed through plastic conduits installed within the walls, without any exposed wiring design. Additionally, ensure that the control switch has a waterproof capacity of at least 10A, especially in older bathrooms where the bath heater is being installed.

2. Bath heater thickness should not be too large

Regarding installation, the thickness of the bath heater should not be excessive, with a recommended thickness of around 20 cm. Since the heater is to be installed on the ceiling, it requires a PVC ceiling panel for adequate installation, ensuring that the back half of the heater fits snugly between the two panels. If the heater is too thick, the ceiling panel must be lowered.

3. Installation location should be at the center of the bathroom

It is not advisable to install the bath heater directly above a bathtub or shower area, as this may seem to provide quick warmth but poses safety risks. The close proximity of infrared radiation lamps to the human body may result in burns. Thus, it is recommended to install tthe bath heater at the central position on the bathroom ceiling to ensure both safety and optimal functionality.

In conclusion：this article has introduced the differences between heating 1 and heating 2 of the bath heater, along with relevant knowledge. We hope this information is helpful. For more related knowledge, please continue to follow our website.