How Many Hours Should Toilet Rim Sealant Dry Before Contacting Water?

During the installation of a toilet, glass adhesive is often used to secure it firmly. It's important to pay special attention to details when using glass adhesive. Below, I will explain how many hours after applying the adhesive on the toilet edge it can be exposed to water.

一、How many hours until the adhesive on the toilet edge can be exposed to water

Typically, it takes about 24 hours or more, depending on the type of glass adhesive used. If acidic glass adhesive is applied, it usually cures completely in about 24 hours. In contrast, if neutral glass adhesive is used, the curing time is longer, typically around 48 hours. Additionally, environmental conditions can affect the drying time of the adhesive; if the environment is humid or poorly ventilated, drying will take longer.

二、What to pay attention to when installing a toilet

1、Before installation, inspect the drainage pipe to check for any mud or debris inside. If not addressed, it may lead to future blockages. To check, pour a large bucket of water into the drain. If you hear a clattering sound, it indicates that there is debris inside the pipe, which should be cleared before installation.

2、Measure the distance from the center of the drainage hole to the wall before installing the toilet. Purchase a toilet that matches this measurement; otherwise, there may be a significant gap or it may not fit. If there are tiles on the wall, reduce the measured distance by 3-5 cm for an accurate size.

3、Ensure that the floor is clean before installation to prevent the toilet from wobbling. After securing the toilet, use glass adhesive to bond the base to the floor, which helps prevent odors from the drainage pipe from entering the room through any gaps.

In summary：regarding how many hours the adhesive on the toilet edge can be exposed to water, it typically takes around 24 hours or more, depending on the type of glass adhesive used. I hope the information provided is helpful to everyone.