Step-by-Step Guide: How to Install a Shower Door Water Strip

Many people equip their shower rooms with water blocking strips, but most are not very familiar with them. So, how do you install water blocking strips in a shower room?

Easy DIY Tips for Installing Shower Door Water Strips

1. During tile installation, first reserve a slot. Once the cement and sand are leveled, place the marble water blocking strip into the slot.

2. Form the shape of the water blocking strip using bricks, and then add tiles, stones, or other materials to the outer layer.

3. During the installation of the floor tiles, embed the water blocking strip within the tiles. The skirt edge should be at the edge of the water blocking strip and raised a few millimeters. This type of water blocking strip is to serve as a base for the glass in the shower room. The glass should be positioned in the middle of the water blocking strip so that the skirt edge can prevent water from entering from below the glass.

4. For water blocking strips that accompany shower curtains, it is essential to confirm the height during installation to ensure that the shower curtain drapes naturally about three centimeters inside the water blocking strip. This will guarantee an effective barrier, preventing water from splashing out after installation.

5. A drawback of the skirted type is that if there is no glass pressing down on the upper part of the water blocking strip, uneven pressure may occur inside and outside the strip. Over time, the silicone seal below may loosen.

6. Many people prefer to install the water blocking strip upright; however, this is unnecessary. As long as the height is maintained at 1.8 cm, if the highest point is reached and the floor drain still cannot drain, it indicates that the issue lies with the floor drain itself, not the water blocking strip.

Installation Notes for Shower Room Water Blocking Strips:

1. From an overall perspective, dimensions, shower heads, faucets, and electrical wiring must be properly reserved. During plumbing construction, confirm the reserved locations and consult the manufacturer for relevant precautions.

2. Water blocking strips should typically be embedded before laying tiles. This way, even after prolonged use, concerns about water seepage will be alleviated.

In summary：the above outlines the installation steps for water blocking strips in a shower room. There are two methods of installation, and the choice depends on our actual circumstances. This approach can ensure a smooth installation and help avoid many troubles. I hope this information can be helpful to everyone.