Effective Methods to Make Shower Room Floors Anti-Slip

When people renovate their bathrooms, they not only pay attention to the separation of wet and dry areas but also to slip resistance. So, what methods can be used for slip resistance on the shower room floor? What should be noted during the renovation of the shower room? Let’s take a look!

Methods for achieving slip resistance on the shower room floor:

Firstly, you can lay pebble stones, which are not only cost-effective but also offer good slip resistance and can provide a foot massage effect. Secondly, you can groove the floor tiles or choose slip-resistant ceramic tiles for installation. Lastly, you may consider using slip-resistant mats or selecting anti-corrosion wood that is both waterproof and slip-resistant.

Things to pay attention to when renovating the shower room:

1. Wiring before shower room renovation

Firstly, the installation of the shower room should not be arbitrary. Before renovation, a reasonable layout should be planned, and the switch arrangements should be done properly to avoid the risk of electric leakage. The position of the shower room should also be determined; if it's not suitable, adjustments should be made to avoid wasting space and causing inconvenience during use.

2. Determining the size of the shower room

Next, when installing the shower room, you need to consider the area of the bathroom and the installation height. If the shower room is too large or the installation height is too high, it may create an uncomfortable feeling. The typical height of the shower room is around 2.1 meters, but during actual operations, it may need to be increased by approximately 10 centimeters, and a water barrier should be pre-set.

3. Selection of shower room glass

When renovating the shower room, attention should also be paid to the glass and other fittings. Some may believe that thicker glass is always better, but in fact, a pivoting shower room has larger glass areas yet poor stability. Therefore, it's essential to choose thicker glass, preferably over 5 millimeters for tempered glass. For fan-shaped and square shower rooms, glass thickness of 5 millimeters is sufficient.

4. Preventing leakage in the shower room

Finally, attention should be given to the issue of water leakage in the bathroom during the renovation of the shower room. Since bathrooms use a lot of water, it's important to regularly check for signs of leakage when installing the shower room and promptly address any issues to avoid future complications.

In summary：the above is an introduction to methods for achieving slip resistance on shower room floors and points to consider when renovating a shower room. I hope this information helps those in need. If you need more related knowledge in the future, feel free to follow our website.