Upgrade Your Bathroom: How to Install a New Showerhead

Before installing the showerhead, it is essential to understand the correct position for installation to avoid any impact on its use. Below, we will introduce how to install a showerhead.

How to Install a Showerhead

First, turn off the water supply. Place the rubber washer on a section of the pipe, then tighten the connection between the pipe and the water inlet. After that, connect the showerhead to the pipe. Once installed, test the showerhead by turning it on; if everything is working properly, it is ready for use.

Daily Maintenance of the Showerhead

1. When using the showerhead, ensure that the water temperature is below 70 degrees Celsius. Excessive heat can accelerate the aging of the showerhead, potentially shortening its lifespan. Additionally, the installation position of the showerhead should be based on the principles of electrical heating sources and should not be installed directly beneath the bathroom heater; a distance of around 60 cm should be maintained between the two.

2. The showerhead typically uses a metal hose, which allows for natural flexibility during use. When using it, make sure to coil the hose on the faucet. It is important to note that there are connection points between the hose and the faucet, and these should not create any blind spots, as this might cause the hose to become kinked or damaged.

3. If the showerhead has been used for over six months, it is advisable to remove it for maintenance. Place the showerhead in a basin and soak it in some white vinegar to clean both the surface and interior. After a few days, use a cotton cloth to wipe the water outlet of the showerhead, and then rinse it thoroughly with white vinegar.

In summary：this concludes the introduction on how to install a showerhead. You can follow the methods outlined above during installation. Pay special attention to the details to avoid unnecessary troubles.