Understanding and Resolving Odors from the Two Holes of Your Toilet

Toilets are common bathroom fixtures in households, convenient to use. However, over time, they may encounter issues. What should you do if there is a foul smell coming from the two holes at the back of the toilet? What should you pay attention to when installing a toilet? Let's take a look!

一、What to do if there is a foul smell from the two holes at the back of the toilet:

The two holes at the back of the toilet are primarily used for securing the toilet to the floor with screws. If there is an odor, it is often due to a poorly sealed toilet seal. It is advisable to seal the two holes with silicone. If that doesn't help, you may need to disassemble the toilet and reinstall the seal. Additionally, the odor may also result from insufficient cleaning, so be sure to clean it thoroughly.

二、What to pay attention to when installing a toilet:

1、Before installing the toilet, check that the drainage pipes are clear. Fill a bucket with water and pour it down the drain to see if the water level rises. If it does, there may be a blockage that needs to be cleared.

2、When installing the toilet, it is preferable to replace the drainage pipe with a direct line; a P-trap can hinder the toilet's drainage. Also, inspect the sewage pipeline to ensure there is no mud or debris inside. Pay attention to the floor to make sure it is level and try to ensure that it is even.

3、During installation, check whether the P-trap has a glazed surface. It is recommended to choose one that has undergone glazing; otherwise, it may accumulate dirt and become hard to clean over time. When purchasing, you can reach into the toilet's waste outlet to feel if it is smooth for identification.

4、When installing the toilet, determine the center point of the drainage pipe. The simplest method is to turn the toilet upside down and mark the centerline on the drainage outlet. Note that the drainage outlet installation requires a special sealing ring or a ring of silicone sealant.

5、Before installing the toilet accessories, clean the pipes thoroughly and run water for 3-5 minutes. After rinsing, you can install the soft hose and angle valve, and then connect the water source for testing. Additionally, after installing the toilet, conduct a comprehensive inspection to check for any issues such as blockage in the fill valve or absence of a filtering device.

summary：

this article covers the foul smell from the two holes at the back of the toilet and the essential considerations for toilet installation. We hope this information can be helpful to those in need. For more knowledge in the future, feel free to follow Hawkrown Network for updates.