How to Install a Shower Without a Pre-Embedded Stone Base

To achieve better separation of wet and dry areas, many people choose to pre-embed a stone base in their shower rooms. However, what should you do if the shower room does not have a pre-embedded stone base? Let's explore the relevant knowledge below.

What to do if there is no pre-embedded stone base in the shower room

If a stone base is not pre-embedded in the shower room, you can choose to place the stone base on top of the floor tiles and use silicone sealant around the edges of the stone base. However, it is essential to ensure that the waterproofing and drainage measures under the bathroom tiles are properly executed to prevent any leakage. Additionally, the silicone sealant needs to be replaced regularly; otherwise, over time it may become discolored, cracked, or lead to water leakage.

What to pay attention to when pre-embedding the stone base in the shower room

1. Before pre-embedding the stone base, you should first ensure that the walls of the bathroom have been properly waterproofed and that the wall tiles have been installed, while also making sure the wall surface remains even.

2. Next, the stone base should be positioned on the unlaid floor tiles, and the side edges of the stone base should be tightly pressed against the previously installed wall tiles. However, the actual ends of the stone base should not be embedded into the wall tiles.

3. You should then measure the right angle distance between the outer edge of the stone base and the corner of the wall with a ruler, and adjust the stone base's specific position according to actual circumstances to ensure that the right angles at both ends of the stone base remain consistent with the pre-embedded stone base.

4. Place a level on the surface of the stone base to ensure it is oriented correctly, then secure the stone base in place. Once the stone base is securely fixed, you can begin laying the floor tiles. During this process, the stone base should be embedded into the tiles, and the surfaces of both should remain flush. It is crucial not to embed the stone base too deeply. Additionally, it is best to minimize the use of silicone sealant between the cut edges of the stone base and the wall tiles.

In summary：The above is a detailed introduction on what to do if there is no pre-embedded stone base in the shower room and what to pay attention to when pre-embedding the stone base. I hope it can help those who need to install a shower room. It is recommended to pre-embed the stone base beforehand to avoid issues during later use.